Ironwork

Rubber and General Products

Handles and Locks

Hinges and Stays

Cargo Control and Steps

Lighting and Electrical Equipment

Ventilation and Heating

Sealants and Consumables

Online Catalogue > Lighting and Electrical Equipment > Interior Lights - Fluorescent

	MXT Series Surface Mounting Supplied 12 or 24 Volt Details
	Component

	XT Series Surface Mounting Unique Design of Interlocking Chassis and Diffuser Twin Transistor Inverter with Radio Interference Suppression Supplied only 12 or 24 Volt Details
	Component

	Covex Series Surface Mounting Suitable for Cove Mounting or a Single Run along a Centre Aisle Converts to Continuous Run with Link Cap Extruded Aluminium Chassis with High Impact Diffuser Supplied 12 or 24 Volt Details
	Component

	Low Profile Covex Series Surface Mounting for use where a Low Profile is required Suitable for Cove Mounting or a Single Run along a Centre Aisle Converts to Continuous Run with Link Cap Extruded Aluminium Chassis with High Impact Diffuser Supplied 12 or 24 Volt Details
	Component

	SL Series Surface Fixing Low Profile for Restricted Headroom Use Finish - White Stove Enamelled heavy gauge Aluminium Choice of Single or Twin Tubes Supplied 12 or 24 Volt Available switched if required Details
	Component

	TR Series Corner Lights that fit neatly against ductwork or where roof corners are at right angles and easily converts to continuous by fitting link caps Extruded Aluminium Chassis and High Impact Diffuser Supplied 12 or 24 Volt Details
	Component

	RL Series Semi-Recessed Low Protrusion (18mm) suitable for where headroom is restricted Finish - White Stove Enamelled on heavy gauge Aluminium with High Impact Diffuser Choice of Single or Twin Tubes Available Switched. Supplied 12 or 24 Volt Details
	Component

	AL Series Semi-Recessed Low Profile (30mm) One Piece Injection Moulded Diffuser ensures maximum headroom. Supplied 12 or 24 Volt Ambulance Version has special colour matched tube Details
	Components

	FLR Series Recessed Light designed specifically for areas where headroom is restricted (8mm protrusion) Polycarbonate Diffuser
	Components

	DB Series Batten Type Lights Designed for back illumination of destination boards, pay as you enter signs etc. Finish White Stove Enamel on Rigid Aluminium Chassis Supplied without diffuser Details
	Components

	Gear Trays Aluminium Chassis fitted with Tube Holder, Tube and Inverter Details
	Component

	Inverters Wide Range to Suit Bus, Coach and Specialist Vehicles Finish - Aluminium Case with ABS End Caps High Efficiency 11 Watt PL Tube Supplied 12 or 24 Volt Details
	Component

	Weather Proof Light Vandal Resistant Light - Weather Proof to IP65 Finish - White Polycarbonate High Efficiency 11 Watt PL Tube Details
	Voltage

Online Catalogue > Lighting and Electrical Equipment > Interior Lights - Fluorescent